Fuji Xerox DocuCentre SC2020 User Manual

Error Code
267
Problem Solving
13
Error Code
This section describes error codes.
An error message and error code (xxx-xxx) are displayed if printing terminated abnormally
because of an error, or a malfunction occurred in the machine.
Refer to the error codes in the following table to resolve problems.
Important • If an error code is displayed, any print data remaining in the machine and information stored in the
machine's memory is not secured.
If an error code is displayed that is not listed in the following table, or if you cannot resolve
an error despite following the instructions described in the table, contact our Customer
Support Center.
Error Code Remedy
005-942 The original size is not detected accurately. Check the originals loaded in the
document feeder, reload the originals, and then press the <Start> button.
Note • When using a non-standard size document, specify the original size in
[Original Size]. Depending on the selected document size, the printout
may be too large for the paper or may have shadows at the edges.
016-503 Select [Close], or wait for the time set in [Fault Timeout] for the machine to
recover. Check if the SMTP server and the DNS server are set correctly on
CentreWare Internet Services.
016-504 Select [Close], or wait for the time set in [Fault Timeout] for the machine to
recover. Check if the POP3 server and the DNS server are set correctly on
CentreWare Internet Services.
016-505 Select [Close], or wait for the time set in [Fault Timeout] for the machine to
recover. Check if the user name and password used for the POP3 server are set
correctly on CentreWare Internet Services.
016-506 Select [Close], or wait for the time set in [Fault Timeout] for the machine to
recover. Check if the SMTP server or the POP3 server is set on CentreWare
Internet Services.
016-507 Select [Close], or wait for the time set in [Fault Timeout] for the machine to
recover. Check if the user name and password used for the SMTP server are
set correctly on CentreWare Internet Services.
016-520
016-521
Contact your system administrator.
016-570
016-571
016-572
016-573
016-718
016-720
Select [Close], or wait for the time set in [Fault Timeout] for the machine to
recover.
016-737
016-741
016-742
016-743
016-744
016-745
Switch off the machine power, make sure that the touch screen is blank, and
then switch on the machine power. Contact our Customer Support Center if
this failure is repeated.
016-746 Select [Close] to recover the machine.
016-757
016-758
016-759
Contact your server administrator.

Fuji Xerox DocuCentre SC2020 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre SC2020
Category	All in One Printer
Language	English