Understanding the Machine Menus
159
Tools
9
Network Setup
Use the [Network Setup] menu to change the machine settings affecting jobs sent to the
machine through the network.
Note • Bold values are the factory default menu settings.
îš„ Ethernet
Purpose:
To confirm or specify network settings.
z
IP Mode
Purpose:
To configure the IP mode.
Values:
z
TCP/IP
Purpose:
To configure TCP/IP settings.
Values:
On Enables the Ignore Form Feed feature.
Dual Stack Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv6 Mode Uses IPv6 to set the IP address.
Get IP Address DHCP / AutoIP Sets the IP address automatically. A random
value in the range of "169.254.1.0" to
"169.254.254.255" that is not currently in use
on the network is set as the IP address. The
subnet mask is set as "255.255.0.0".
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel Use this option when you want to set the IP
address manually on the control panel.
IP Address When an IP address is being set manually, the
IP is allocated to the machine using the
format "nnn.nnn.nnn.nnn". Each octet that
makes up "nnn.nnn.nnn.nnn" is a value in the
range of "0" to "254". "127" and any value in
the range of "224" to "254" cannot be
specified for the first octet of a gateway
address.
Subnet Mask When an IP address is being set manually, the
subnet mask is specified using the format
"nnn.nnn.nnn.nnn". Each octet that makes up
"nnn.nnn.nnn.nnn" is a value in the range of
"0" to "255". "255.255.255.255" cannot be
specified as the subnet mask.
To Next Page
Loading...
Need help?
General
