3 Product Overview
50
Product Overview
3
Power Source
Switching the Power On
The following describes how to switch the power on.
The machine takes approximately 39 seconds or less to warm up and to be ready to copy,
print, or fax after the power is turned on. It may take slightly longer than normal depending
on the device configuration.
Switch the power off at the end of the day or when not using the machine for an extended
period of time.
1 Press the power switch to the [ | ] position to
switch the power on.
Note • The "Power up sequence in progress" message
indicates that the machine is warming up. The
machine is not accessible while warming up.
• Make sure that the power cable is connected to
the machine and the wall outlet properly.
Switching the Power Off
The following describes how to switch the power off.
Important •Do not switch the power off in the following situations. If the power is switched off, the processing
data may be erased.
- While data is being received
- While a job is being printed
- While a job is being copied
- While a job is being scanned
• When switching the power off, wait 10 seconds after outputs have been delivered.
Note • When powering the machine on after it has been switched off, wait 15 seconds after the display
goes off.
1 Before switching the power off, make sure that the machine has completed all copy or print
jobs. Then, make sure that the <Data> LED does not light up.
2 Press the power switch to the [ ] position to
switch the power off.
To Next Page
Loading...
Need help?
General
