Fuji Xerox DocuCentre SC2020 User Manual

Machine Problems
247
Problem Solving
13
Machine Problems
Check the machine's status again if you suspect a malfunction.
Symptom Possible Cause Remedy
The machine is
not powered on.
Is the power switched ON? Switch the power ON.
Refer to "Power Source" (P.50).
Is the power cord plugged
into the power outlet?
Switch the power OFF and make sure the
power plug is inserted securely. Then switch
the power ON.
Is the power cord
disconnected from the
machine?
Does the AC outlet supply
power properly?
Connect another appliance to the outlet to
verify the power supply.
The <Error> LED is
blinking.
The system of the machine or
the components installed
may have a trouble.
Switch the power OFF, then ON again. If the
problem persists, contact our Customer
Support Center.
The <Error> LED is
lit.
Is paper or document
jammed?
Remove the jammed paper or document.
Refer to "Paper Jams" (P.274).
Refer to "Document Jams" (P.278).
Is the machine front cover or
another cover open?
Follow the instructions in the displayed error
code to take the required action.
Refer to "Error Code" (P.267).
The display is
dark.
Is the <Power Saver> button
lit?
The machine is in an Power Saver mode. Press
the control panel's <Power Saver> button to
turn off the Power Saver mode.
Unable to print
or copy.
Is there an error code
displayed in the control
panel's display?
Follow the instructions in the displayed error
code to take the required action.
Refer to "Error Code" (P.267).
Is the power cord connected? Switch the power OFF and make sure the
power plug is inserted securely into the power
outlet. Then switch the power ON.
The <Data> LED
does not light
even though you
instructed the
machine to print.
Is the interface cable
connected?
Check the interface cable connection.
Refer to "Interface Cables" (P.32).
Is the computer's
environment correctly set?
Check the computer environment such as
print driver settings.
Is the required port status set
to [Enabled]?
Check the status of the port to use, and then
set the port status to [Enabled].
Refer to "Activating the Communication Port To Use"
(P.39).
Unable to print
although a print
job is instructed to
Tray 5 (bypass).
Is the specified paper size
loaded in the tray?
Follow the instructions in the displayed error
code to place paper of the correct size, and
then try again.
Refer to "Error Code" (P.267).
Refer to "Loading Paper in Tray 5 (bypass)" (P.66).
The print quality
is poor.
An image quality problem
may have occurred.
Take the required action described in "Image
Quality Problems".
Refer to "Image Quality Problems" (P.251).

Fuji Xerox DocuCentre SC2020 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre SC2020
Category	All in One Printer
Language	English