▶
Reboot your system.
Y
our system will now start with Legacy Boot.
When starting your system with Legacy Boot, the different vendor tools will be
displayed on the screen.
▶
Press the required key to enter into the vendor tool.
▶
Step forward to get access to the address of interest.
5.3.16.3 Looking for the WWN address of a fibre channel controller
There are several possible locations where these addresses can be found.
▶
Inform the customer about the new or changed WWN address.
Checking the label
▶
If available, check the label on the controller. Beside the part number, you
may find the WWN address.
Using an UEFI BIOS
▶
Enter the BIOS setup menu.
▶
Select the Advanced menu.
The addresses are displayed at the Advanced menu main page.
Only network controllers supporting the Command Line Protocol
(CLP) will be displayed.
Using the vendor tools in a Legacy BIOS
▶
T
o get the WWN address use the vendor tools, see "Using the vendor tools
in a Legacy BIOS" on page 111.
5.3.16.4 Looking for the GUID address of an infiniband or Omni-Path
controller
There are several possible locations where these addresses can be found.
▶
Inform the customer about the new or changed GUID address.
Basic software procedures
112 Upgrade and Maintenance Manual RX4770 M5
To Next Page
Loading...
