4.5.4 Sliding the server into the rack
Figure 10: Sliding the server into the rack
â–¶
Release the locking mechanism of both rails (1).
â–¶
Push the server as far as it will go into the rack (2) until the quick-release
levers engage (3).
CAUTION
â–¶
Be careful with your fingers. You can pinch them when the quick
release levers change to the release position.
â–¶
Reconnect all cables except the power cord to the server rear
.
Basic hardware procedures
RX4770 M5 Upgrade and Maintenance Manual 57