14.5.4 Replacing the iRMC microSD card
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools:
– Phillips PH2 / (+) No. 2 screw driver (for housing cover)
–
a pair of side-cutting pliers
Preliminary steps
▶
"Locating the defective server" on page
43.
▶
"Shutting down the server" on page 45.
▶
"Disconnecting the power cord" on page 46.
▶
"Getting access to the component" on page 47.
▶
Remove the riser module 6/7, see "Removing the riser module 3/4 and 6/7"
on page 61.
▶
"Removing the riser module" on page 64.
Replacing the iRMC microSD card
▶
Remove the defective iRMC microSD card, see "Removing the iRMC
microSD card" on page 329.
CAUTION
(not valid for Europe, Middle East, India and Africa)
The iRMC microSD card contains customer information.
▶
After removing the iRMC microSD card, hand the card over to
the customer
.
▶
If the customer requests disposal of the defective microSD card,
proceed as follows: Using a pair of side-cutting pliers, cut the
microSD card in half.
▶
Install the new iRMC microSD card, see "Installing the iRMC microSD card"
on page 327.
System board and components
RX4770 M5 Upgrade and Maintenance Manual 331
To Next Page
Loading...
