Fujitsu PRIMERGY RX4770 M5 - Page 330

Removing the iRMC microSD card
Figure 185: Removing the iRMC microSD card
▶
T
o eject the iRMC microSD card, gently push it in and then let go (1).
▶
Pull the iRMC microSD card straight out of its slot (2).
CAUTION
(not valid for Europe, Middle East, India and Africa)
The iRMC microSD card contains customer information.
▶
After removing the iRMC microSD card, hand the card over to
the customer
.
▶
If the customer requests disposal of the defective microSD card,
proceed as follows: Using a pair of side-cutting pliers, cut the
microSD card in half.
Concluding steps
▶
"Installing the riser module" on page
65.
▶
Install the riser module 6/7, see "Installing the riser module" on page 65.
▶
"Reassembling" on page 53.
▶
"Connecting the power cord (AC PSU)" on page 58.
▶
"Switching on the server" on page 59.
System board and components
330 Upgrade and Maintenance Manual RX4770 M5