Figure 11: Securing the power cord with the hook-and-loop-tape
▶
Unroll the hook-and-loop-tape (1).
▶
Fix the mains connector of the power cord with the hook-and-loop-tape as
shown in the figure (2).
4.7
Switching on the server
CAUTION
▶
Before switching on the server, make sure the top cover is closed.
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the top cover is removed.
▶
For more information, see "Important information" on page
29.
▶
Press the On/Of
f button to start up the server.
▶
Ensure that the power-on indicator is lit green.
Basic hardware procedures
RX4770 M5 Upgrade and Maintenance Manual 59
To Next Page
Loading...
