Installing the new OCP module
▶
Install the OCP module, see "Installing the OCP module" on page
184.
Concluding steps
▶
Install the riser module 3/4, see "Installing the riser module 3/4 and 6/7" on
page 62.
▶
"Reassembling" on page 53.
▶
"Connecting the power cord (AC PSU)" on page 58.
▶
"Switching on the server" on page 59.
▶
If replacing an OCP module with an OCP module with different number of
ports (e.g. 2-port to 4-port):
▶
Configure the additional MAC addresses in the OS, if you have no VIOM
(ServerView Virtual-IO Manager) installed. If you have VIOM installed, it
is not necessary to configure the MAC address. This is virtualized by
VIOM.
▶
Inform the customer about these MAC addresses, see "Basic
information" on page 110.
▶
If replacing the system board (except OCP module PLAN EP 2x 25G/10G):
▶
Inform the customer about these MAC addresses, see "Basic
information" on page 110.
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 107.
▶
"Configuring LAN teaming" on page 116.
9.6 Installing SFP+ transceiver modules to
OCP modules (optional)
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Expansion cards and backup units
188 Upgrade and Maintenance Manual RX4770 M5
To Next Page
Loading...
