Fujitsu PRIMERGY RX4770 M5 - Page 135

Concluding steps
▶
Push the hot-plug PSU in its bay
, see "Installing a hot-plug PSU" on
page 123.
▶
Connect the VGA cable to the bottom system board, see "Installing the front
panel module" on page 306.
▶
Install the riser module in slot 5, see "Installing the riser module" on
page 65.
▶
If applicable, install the RAID card, see "Installing an expansion card" on
page 190.
▶
Connect the mini-SAS cable near the power distribution board to the bottom
system board.
▶
Install the air duct on the bottom system board, see "Installing the CPU air
duct" on page 74.
▶
"Installing the top system board holder" on page 79.
▶
"Installing the riser module 3/4 and 6/7" on page 62.
▶
"Installing the fan cage" on page 71.
▶
Install the air duct on the top system board, see "Installing the CPU air duct"
on page 74.
▶
"Installing the top covers" on page 53.
▶
"Installing the server in the rack" on page 55.
▶
"Connecting the power cord (AC PSU)" on page 58.
▶
"Switching on the server" on page 59.
▶
"Resuming BitLocker functionality" on page 108.
Power supply unit (PSU)
RX4770 M5 Upgrade and Maintenance Manual 135