Field Description
Group Description Enter the desired description of the interface group.
Distribution Policy Select the way the data traffic is to be distributed to the inter-
faces configured for the group.
Possible values:
• Session-Round-Robin (default value): A newly added
session is assigned to one of the group interfaces according
to the percentage assignment of sessions to the interfaces.
The number of sessions is decisive.
• Load-dependent Bandwidth: A newly added session is
assigned to one of the group interfaces according to the share
of the total data rate handled by the interfaces. The current
data rate based on the data traffic is decisive in both the send
and receive direction.
Consider Only for Distribution Policy = Load-dependent bandwidth
Choose the direction in which the current data rate is to be con-
sidered.
Options:
• Download: Only the data rate in the receive direction is con-
sidered.
• Upload: Only the data rate in the send direction is con-
sidered.
The Download and Upload are deactivated by default.
Distribution Mode Select the state the interfaces in the group may have if they are
to be included in load balancing.
Possible values:
• Always(default value): Also includes idle interfaces.
• Only use active interfaces: Only interfaces in the up
state are included.
In the Interface Selection for Load Balancing area, you add and configure interfaces that
match the current group context. You can also delete interfaces.
Use Add to create entries.
Funkwerk Enterprise Communications GmbH
12 Routing
bintec W1002/W1002n/W2002/WIx040/WIx065 199
To Next Page
Loading...
Need help?
General
