be assigned to dialling-in connection partners for the duration of the connection.
Any host routes entered always have priority over IP addresses from the address pools.
This means if an incoming call has been authenticated, your device first checks whether a
host route is entered in the routing table for this caller. If not, your device can allocate an IP
address from an address pool (if available). If address pools have more than one IP ad-
dress, you cannot specify which connection partner receives which address. The ad-
dresses are initially assigned in order. If a new dial-in takes place within an interval of one
hour, an attempt is made to allocate the same IP address assigned to this partner the last
time.
Use the Add button to set up new IP pools.
Fig. 103: VPN -> IPSec -> IP Pools -> Add
The VPN -> IPSec -> IP Pools -> Add menu consists of the following fields:
Fields in the Options IP Pools menu
Field Description
IP pool name Enter the name of the IP pool.
IP pool range In the first field, enter the first IP address of the range.
In the second field, enter the last IP address of the range.
Funkwerk Enterprise Communications GmbH
14 VPN
bintec W1002/W1002n/W2002/WIx040/WIx065 239
To Next Page
Loading...
Need help?
General
