Field Description
The function is activated with Enabled.
The function is disabled by default.
Prioritize TCP ACK
Packets
Select whether the TCP download is to be optimised in the
event of intensive TCP upload. This function can be specially
applied for asymmetrical bandwidths (ADSL).
The function is activated with Enabled.
The function is disabled by default.
Fields in the Advanced Settings IP Options menu
Field Description
OSPF Mode Select whether and how routes are propagated via the interface
and/or OSPF protocol packets are to be sent.
Possible values:
• Passive (default value) OSPF is not activated for this inter-
face, i.e. no routes are propagated or OSPF protocol packets
sent over this interface. Networks reachable over this inter-
face are, however, included when calculating the routing in-
formation and propagated over active interfaces.
• Active: OSPF is activated for this interface, i.e. routes are
propagated or OSPF protocol packets sent over this interface.
• Down : OSPF is disabled for this interface.
Proxy ARP Mode Select whether your device is to respond to ARP requests from
its own LAN on behalf of the specific L2TP partner.
Possible values:
• Inactive (default value): Deactivates Proxy ARP for this
L2TP partner.
• Up or Dormant: Your device only responds to an ARP re-
quest if the status of the connection to the L2TP partner is Up
(active) or Dormant. In the case of Dormant, your device
only responds to the ARP request; the connection is not set
up until someone actually wants to use the route.
• Active Only: Your device responds to an ARP request only
if the status of the connection to the L2TP partner is Up
14 VPN Funkwerk Enterprise Communications GmbH
252 bintec W1002/W1002n/W2002/WIx040/WIx065
To Next Page
Loading...
