Access data Example value Your values
IP address of your access point 192.168.0.252
Netmask of your access point 255.255.255.0
Access Point mode
If you run your device in Access Point mode, you can set up the required wireless net-
works. To do this, you need the following data:
Configuration of a wireless network
Access data Example value Your values
Network Name (SSID) Funkwerk-ec
Security Mode WPA-PSK
Preshared Key supersecret
Access Client mode
If you run your device in Access Client mode, you can set up the required client links. To do
this, you need the following data:
IP configuration of the access client
Access data Example value Your values
Network Name (SSID) Funkwerk-ec
Security Mode WPA-PSK
Preshared Key supersecret
Bridge mode
If you run your device in Bridge mode, you can either configure connections to other
bridges manually or use the bridge link autoconfiguration function. For the manual configur-
ation of a bridge link, you need the following data:
Configuration of a bridge link
Access data Example value Your values
Preshared Key bridgesecret
MAC address of remote bridge 00:a0:f9:5a:42:53
To use the bridge link autoconfiguration function, proceed as described in the Automatic
Configuration of a Bridge Link workshop and read the Wireless LAN chapter of the
user's guide under WLAN1 -> Bridge Links -> Add.
4 Basic configuration Funkwerk Enterprise Communications GmbH
16 bintec W1002/W1002n/W2002/WIx040/WIx065