Field Description
field of the email.
Maximum number of
messages per minute
Here you can limit the number of outgoing mails per minute.
Possible values are 1 to 15, the default value is 6.
Fields in the E-mail Alert ServerSNMP Settings menu
Field Description
SMTP Server
Here you enter the address (IP address or valid DNS name) of
the mail server to be used for sending the mail.
The entry is limited to 40 characters.
SMTP Authentication
Here you can forward the incoming e-mails.
Possible values:
• None (default value): The E-mails are not forwarded.
• ESMTP: The E-mails are forwarded to the destination over
SMTP.
• SMTP after POP: The E-mails are collected by the provider
with POP and are forwarded to the destination over SMTP.
User name
Only if SMTP Authentication = ESMTP or SMTP after POP.
Enter the user name of the user.
Password
Only if SMTP Authentication = ESMTP or SMTP after POP.
Enter the password of the user.
POP3 Server
Only if SMTP Authentication = SMTP after POP.
Enter the address of the server from which the mails are to be
retrieved.
Appropriate POP3 server software must be installed so that the
mailserver can answer the requests via POP3.
POP3 Timeout
Only if SMTP Authentication = SMTP after POP.
Enter how long the router must wait after a relevant event be-
fore it is forced to send the alert mail.
Funkwerk Enterprise Communications GmbH
18 External Reporting
bintec W1002/W1002n/W2002/WIx040/WIx065 345
To Next Page
Loading...
Need help?
General
