Fig. 38: BOOTmonitor
After display of the BOOTmonitor prompt, press the space bar within four seconds to use
the functions of the BOOTmonitor. If you do not make an entry within four seconds, the
device changes back to normal operating mode.
Note
If you change the baud rate (the preset value is 9600 baud), make sure the terminal
program used also uses this baud rate. If this is not the case, you will not be able to
establish a serial connection to the device.
7 Access and configuration Funkwerk Enterprise Communications GmbH
82 bintec W1002/W1002n/W2002/WIx040/WIx065
To Next Page
Loading...
