315
4. Press the RF Cursor Zone hardkey to
move to the RF Zone.
5. Move the cursor to the “Freq:” field and
enter the frequency to be monitored by
the analyzer.
6. Set the monitor attenuation and port
selection. Suggested port selection is RF
I/O with 20dB attenuation.
The selected BER measurement type, shown
in the AUD Zone, defaults to a V.52
measurement using the C4FM receiver
algorithm.
1. Start the BER measurement by selecting
the reset softkey.
This will clear any previous BER results
and start the BER measurement. The BER
measurement can be cleared and restarted at
any time by selecting the reset softkey.
To Next Page
Loading...
Need help?
General
