General Dynamics R2600 Series User Manual

J-2
encrypt reset from the Special Functions
page and retry.
J-1.2 SECURENET Option Error
Messages
The following m
essages are very similar. They
are all related to a severe failure of the
SECURENET Option. A general discussion of
the cause follows with a general recommended
solution; basically to reset the R2670 and restart
the powerup sequence.
 SECURENET Failed, Notify Local Service
Rep
 SECURENET Option Timed Out
 SECURENET Option - Illegal CP Request
 SECURENET Option - Bad CP opcode
 SECURENET Option Error
The Option Software is not responding
to the R2670.
qwdId:
Verify that SECURENET is installed,
and at least one encryption algorithm
type is installed. This can be done by
inspecting the Installed Options window
from the Special Functions page.
If the options are installed, press the
encrypt reset key from the system
functions line on the Special Functions
window. This will reset the R2670.
Retry the test or procedure. If the
message is redisplayed, perform an nvm
clear from the system functions line
(note: this will erase all parameters
previously input). Retry the test. If the
message is redisplayed, contact your
local service representative.
J-2 WARNINGS
SECURENET Warnings also fall into two
categories: Informational Warnings and User
Prompt Warnings. Informational Warnings
provide feedback to the user, informing the user
of results of actions. User Prompt Warnings
prompt the user to perform some action to
continue.
J-2.1 SECURENET Informational
Warnings
The following SECURENET Informational
Messages occur as the result of some user or
system action.
EOM Detected
End Of Message detected. This message
appears after the release of PTT,
confirming the release.
qwdId:
Nothing, informational only.
Internal Key Loaded
This message means that an internal key
selected has been successfully loaded.
This message will remain displayed until
another message is loaded or erased.
This message continues to be displayed
to remind the user what type of key is
loaded while other Display Screens are
selected (i.e. Modulation Scope
displayed).
qwdId:
Nothing, informational only.
Warning – SECURENET Mode Error
This message is displayed when the
EMC failed to enter SECURENET
Mode. This is typically caused by No
key or a bad key internally loaded.
qwdId:

General Dynamics R2600 Series Specifications

General

Brand	General Dynamics
Model	R2600 Series
Category	Measuring Instruments
Language	English