messages are informational only and do
not require any user action.
External Key Load Passed
An External Key has been
successfully loaded into the EMC.
Keyload in Progress
The operator has selected the load
ext key softkey and then pressed
PTT on the KVL.
External Key Erased
The user has erased a previously
loaded External Key.
External Keyload Canceled
The user has chosen to cancel a key
load operation. The system has been
restored from key load mode back to
normal operating mode.
E-2.2 Project 25 User Prompt
Warnings
Verify Correct Network ID
When generating Project 25 VOICE,
this message indicates that the user
has not entered a valid Network ID.
qwdId:
In the Audio Zone, cursor down to
VOICE FRAME. Select display
table. Change the Network ID to a
nonzero value.
Press KVL PTT to Start Keyload
The user has selected load ext key.
The R2670 is now in key load mode
and is awaiting the start of the key
loading function from the KVL.
qwdId:
Press the KVL PTT to start the key
load or press the cancel softkey to
terminate the key load.
Secure Mode Failure
User is attempting to run a secure
voice scenario but is unable to load
an algorithm or key into the
Encryption Module.
qwdId:
Press the encrypt reset softkey.
Warning-Encryption Hardware Failure
One or more algorithms is installed
in the R2670 via the Monitor Service
Software (MSS) but were not
detected on either Encryption
Module.
qwdId:
Notify the Service Representative.
To Next Page
Loading...