GW Instek GPT-10000 Series

To Next Page

To Previous Page

GPT-10000 Series User Manual

Manual Tests

This section describes how to create, edit and run a single ACW,

DCW, IR, GB and CONT manual tests. Each Manual setting

described in this chapter only applies to the selected manual test – no

other manual tests are affected.

Each manual test can be stored/recalled to/from one of 100

memory locations. Each stored manual test can be used as a test

step when creating an AUTO test (page 104).

 Setting the Test Function → from page 41.

 Choose/Recall a Manual Test Number → from page 42.

 Creating a MANU Test File Name → from page 43.

 Setting the Upper and Lower Limits → from page 44.

 Setting the Test Time → from page 47.

 Setting the Ramp Up Time → from page 49.

 Setting the Ramp Down Time → from page 51.

 Setting the Test Voltage or Test Current → from page 53.

 Setting the Test Frequency → from page 55.

 Setting a Reference Value → from page 56.

 Setting an Initial Voltage → from page 57.

 Setting the Wait Time → from page 59.

 Setting the ARC Function → from page 61.

 Setting MAX HOLD → from page 64.

 Setting PASS HOLD → from page 65.

 Setting IR Mode → from page 66.

 Setting GND OFFSET → from page 68.

 Setting GB Contact → from page 69.

 Zero Check for the Test Leads → from page 71.

 Setting the Grounding Mode → from page 74.

 Setting Contact Check → from page 81.

 Setting IRMode Filter → from page 86.

 Screenshot Hardcopy → from page 86.

 Running a MANU Test → from page 92.

 PASS / FAIL MANU Test → from page 97.

 Special MANU Test Mode (000) → from page 102.

 Sweep Function → from page 104.

GW Instek GPT-10000 Series - Manual Tests