GPT-10000 Series User Manual
126
Automatic Test Results
If all the test steps are allowed to run to
completion (the AUTO test is not stopped or a
protection setting is not tripped) then the tester
will judge each step as either PASS or FAIL.
This is shown as a table after the automatic test
has finished running. If the test has been
stopped, then any remaining tests will not be
run and thus the AUTO test will not finish
running.
AUTO TEST result indicator
MANU STEP results indicators
The PASS/FAIL/STOP result shown on the
top-right corner for an AUTO TEST as a whole
depends on the results of all the steps (MANU
STEPs) that compose an AUTO TEST:
If Interlock function is enabled but without
interlock inserted into Signal I/O port, the
Interlock Open message will be shown on top-
right corner and AUTO test will be unable to
start. Refer to page 157 for details.
To Next Page
Loading...
