GW Instek GPT-10000 Series - Running an Automatic Test

GPT-10000 Series User Manual
120
Running an Automatic Test
Background
An automatic test can be run when the tester is
in READY status.
Note
The tester cannot start to run an AUTO test
under the following conditions:
 Any protection modes have been tripped.
 The INTERLOCK function is ON and the
Interlock key is not inserted in the signal I/O
port (page 185).
 The STOP signal has been received remotely.
If Double Action is ON, ensure the START
button is pressed immediately after the STOP
button (<0.5s).
Warning
Do not touch any terminals, test leads or the DUT
when a test is running.
Steps
1. Ensure the tester is in READY
status for the AUTO test to come.
Page 108
READY status indicator