Harmonic ProView 2900 - Page 71

Chapter 5: Operation and Management ProView 2900 Status Menu
© Harmonic Inc. Manual p/n 101543/Ver 1.0 5-17 ProView 2900 Series/SW Version 1.94
• Frequency Offset - Displays the offset from the frequency as was set in
Configuration 

 Receiver 

 Frequency (see Section 6.2).
• When Frequency Drift Compensation is set to On, the frequency offset
displays the value 0.
• When Frequency Drift Compensation is set to Off, frequency offset displays
the value of the offset from the tuned frequency in KHz.
• FEC Rate – When FEC Rate mode is set to automatic (see FEC Rate parameter in
section 6.2), the value displayed is selected by the ProView 2900. The FEC rate can also
be configured manually to a specific rate by the operator.
• Spectral Inversion – When the Spectral Inversion mode is set to automatic (see Section
6.2), the value displayed is the one selected by the device. Otherwise, this parameter
displays the Spectral Inversion method that was selected manually.
5.4.1.4. IP Receiver Status
The IP Receiver status menu enables monitoring the main IP receiver parameters. It displays
both static information (such as MPEGoIP port MAC Address) and live data (e.g. type of data
encapsulation received, current bit rate, whether or not IP parameters are valid, etc.).
To access the IP Receiver status menu in the front panel interface go to Status 

 Receiver
The IP Receiver status menu as displayed on the ProView 2900 front panel screen:
Receiver
Receiver Receiver
Receiver 1
11
1-
--
-3
33
3-
--
-1
1 1
1
1 MPEG
1 MPEG1 MPEG
1 MPEGoIP Input 1
oIP Input 1oIP Input 1
oIP Input 1
2 MPEGoIP Input 2
2 MPEGoIP Input 22 MPEGoIP Input 2
2 MPEGoIP Input 2
3 General
3 General3 General
3 General
The available options are:
• MPEGoIP Input 1 – for monitoring receiver data arriving through the MPEGoIP IN1
interface
• MPEGoIP Input 2 - for monitoring receiver data arriving through the MPEGoIP IN2
interface
• General – for viewing general parameters values, such as software and hardware
version number, IP configuration consistency, type of detected encapsulation, bit-rate of
currently received data, etc.
The following paragraphs detail the IP Receiver Status sub menus.