smart.Turn units | Units – Centric drilling
2
106
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Global form:
G14: Tool change point
No axis
0: Simultaneously
1: First X, then Z
2: First Z, then X
3: Only X
4: Only Z
5: Only Y (machine-dependent)
6: Simultaneous w/ Y (machine-dependent)
CLT: Coolant
0: Without
1: Coolant 1 on
2: Coolant 2 on
SCK: Safety clearance in infeed direction during drilling and
milling operations
G60: Protection zone – protection zone monitoring during
drilling
0: Active
1: Inactive
BP: Interval time – time span for interruption of the feed
The chip is broken by the (intermittent) interruption of the feed.
BF: Feed period – time interval until the next break
The chip is broken by the (intermittent) interruption of the feed.
Further forms:
Further information: "smart.Turn unit", Page 78
If X is not programmed or XS is in the range of –2 mm <
XS < 2 mm, then the control drills at XS.
Access to the technology database:
Machining operation: Drilling
Affected parameters: F, S
To Next Page
Loading...
