DIN/ISO programming | Programming in ISO Mode
4
232
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
4.1
Programming in ISO Mode
Geometry and machining commands
The control also supports structured programming in ISO Mode.
The G commands are divided into:
Geometry commands for describing the blank and finished
part
Machining commands for the MACHINING section
Some G codes are used for blank/finished-part definition
and in the MACHINING section. When copying or shifting
NC blocks, keep in mind that geometry functions
are used exclusively for describing a contour, while
machining functions are used only in the MACHINING
section.
To Next Page
Loading...
