NC programming | Fundamentals: smart.Turn editor
1
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
51
Shared menu items
The menu items described below are used both in smart.Turn
mode and in ISO Mode.
Prog menu item
The Prog (Program management) menu item contains the following
functions for NC main and subprograms:
Open …: Load existing programs
New: Create new programs or an Automatic jobs
Close: The selected program is closed
Close all: All open programs are closed
Save: The selected program is saved
Save as…: The selected program is saved under a new name
Direct opening of the last four programs
When an NC program is opened or when a new NC program
is created, the soft-key row is switched to the sorting and
organization functions.
Further information: "Sorting and file organization", Page 56
Head (program head) menu item
The menu item Head (program head) contains functions for editing
the program head and the tool list.
Program head: Edit the program head
Go to chucking equipment: Positions the cursor in the
CHUCKING EQUIPMENT section
Insert chucking equipment: Describe how the workpiece is
clamped
Go to turret list (Go to tool list): Positions the cursor in the
TURRET section
Set up the turret list (Setup the tool list): activates the "Set up
turret list" function
Further information: "Setting up a turret list", Page 70
Go to magazine: Positions the cursor in the MAGAZINE section
(machine-dependent)
Set up magazine list: Activates the "Set up magazine list"
function (machine-dependent)
To Next Page
Loading...
