DIN/ISO programming | Contour-based turning cycles
4
338
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Measuring cut G809
Cycle G809 performs a cylindrical measuring cut with the length
defined in the cycle, moves to the breakpoint for measuring and
stops the program. After the program was stopped, you can manually
measure the workpiece.
Parameters:
X: Start point X
Z: Start point Z
R: Length of measuring cut
P: Measuring cut oversize
I: Breakpoint Xi for measuring – incremental distance to starting
point of measurement
K: Breakpoint Zi for measuring – incremental distance to starting
point of measurement
ZS: Start point blank – collision-free approach for inside
machining
XE: Departure position X
D: Additive correction (numbers: 1 to 16)
V: Measuring cut counter – number of workpieces after which a
measurement is performed
Q: Mach. direction (default: 0)
0: –Z
1: +Z
EC: Machining location
1: Outside
-1: Inside
WE: Start t.
0: Simultaneously
1: First X, then Z
2: First Z, then X
O: Approach angle
If an approach angle is entered, the cycle positions the tool over
the starting point taking into account the safety clearance and
from there plunges at the specified angle to the diameter to be
measured.
To Next Page
Loading...
