DIN/ISO programming | Other G codes
4
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
449
Load monitoring G996
G996 defines the type of load monitoring or deactivates the load
monitoring temporarily.
Parameters:
Q: Lib. switch – range of load monitoring (default: 0)
0: Off
1: G0 Off (do not monitor rapid traverse movements)
2: G0 On (monitor rapid traverse movements)
H: Monitoring 0-2 – type of load monitoring (default: 0)
0: Utilization and total utilization
1: Utilization only
2: Total utilization only
In addition to defining the type of load monitoring with
G996, you need to specify the monitoring zone with
G995.
Further information: "Monitoring zone G995", Page 448
To be able to use the load monitoring you must also
define limit values and perform reference machining.
Further information: User's Manual
Example: G996
. . .
N1 G996 Q1 H1
Switch on load monitoring; do not monitor rapid traverse
movements
N2 T4
N3 G995 H1 ID"X0"
. . .
Machining
N9 G995
. . .
To Next Page
Loading...
