DIN/ISO programming | Conditional block run
4
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
483
Skip level
In the Program run submode you can set and activate skip levels.
Then the control does not execute the NC blocks defined with the set
and activated skip level in the next program run.
Further information: User's Manual
Before you can set and activate skip levels, you need to define
them in the program:
Open the program in the smart.Turn operating
mode
Position the cursor in the MACHINING program
section on the NC block to be skipped
Select the Extras menu item
Select the Skip level… menu item
The control opens a pop-up window
Enter the number of the skip level in the /
Deletion parameter
Press the OK soft key
You can assign more than one skip level to an NC block by
entering a string of numerals in the / Deletion parameter.
The entry 159 corresponds to the skip levels 1, 5 and 9.
To clear the defined skip levels, program the parameter
without a value and press the OK soft key to confirm.
To Next Page
Loading...
