HEIDENHAIN CNC PILOT 640 - Units - milling, lateral surface (C axis)

smart.Turn units | Units – milling, lateral surface (C axis)
2
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
183
2.10 Units – milling, lateral surface (C axis)
Slot, lateral surface unit
The unit mills a slot from the starting position to the end point on
the lateral surface. The slot width equals the diameter of the milling
cutter.
Unit name: G792_Nut_MANT_C / cycle: G792
Further information: "Linear slot, lat. surface G792", Page 407
Cycle form:
X1: Upper edge of milling
X2: Milling floor
L: Slot length
A1: Angle to Z axis (default: 0°)
Z1, C1: Polar slot target point
P: Maximum infeed
FZ: Approach feed (default: active feed rate)
Further forms:
Further information: "smart.Turn unit", Page 78
Access to the technology database:
Machining operation: milling
Affected parameters: F, S, FZ, P