smart.Turn units for the Y axis | Units – Drilling in Y axis
3
206
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
ICP boring/countersinking, Y axis unit
The unit machines a single hole or a hole pattern in the XY or YZ
plane. Using ICP, you define the hole positions as well as further
details for boring or countersinking.
Unit name: G72_ICP_Y / cycle: G72
Further information: "Boring/cnt-sink G72", Page 375
Pattern form:
FK: ICP contour number
NS: Starting block no. of contour – beginning of contour
section
Cycle form:
E: Period of dwell at end of hole (default: 0)
D: Retraction type
0: Rapid traverse
1: Feed rate
RB: Return plane (default: back to start position)
Further forms:
Further information: "smart.Turn unit", Page 78
Access to the technology database:
Machining operation: Drilling
Affected parameters: F, S
To Next Page
Loading...
