smart.Turn units | Units – milling, face (C axis)
2
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
169
2.9 Units – milling, face (C axis)
Slot, face unit
The unit mills a slot from the starting position to the end point on
the face of the workpiece. The slot width equals the diameter of
the milling cutter.
Unit name: G791_Nut_Stirn_C / cycle: G791
Further information: "Linear slot, front face G791", Page 406
Cycle form:
Z1: Upper edge of milling
Z2: Milling floor
L: Slot length
A1: Angle to X axis (default: 0°)
X1, C1: Polar slot target point
XK, YK: Cartes. slot target pnt
P: Maximum infeed
FZ: Approach feed (default: active feed rate)
Further forms:
Further information: "smart.Turn unit", Page 78
Access to the technology database:
Machining operation: milling
Affected parameters: F, S, FZ, P
To Next Page
Loading...
