HEIDENHAIN CNC PILOT 640 - Tool programming

NC programming | Tool programming
1
70
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
1.4 Tool programming
This function is also available on machines with a tool
magazine. The control uses the magazine list instead of
the turret list.
The designations of the tool pockets are fixed by the machine tool
builder. Each tool holder has a unique tool number.
In the T command (MACHINING section) you program the tool
number, and therefore the position to which the tool carrier rotates.
The control retrieves the assignment of the tools to the swivel
position from the turret list of the TURRET section.
You can edit the tool entries individually, or you can call the turret list
via the Set up the turret list menu item and then edit it.
Setting up a turret list
This function is also available on machines with a tool
magazine. The control uses the magazine list instead of
the turret list.
In the Set up the turret list function, the control provides the
turret assignment as a tool list for editing.
You have the following options:
Editing the turret assignment: Transfer tools from the database,
delete entries or move them to other positions
Loading the turret list of the Machine mode of operation
Deleting the current turret assignment of the NC program
Soft keys in turret list
Delete entry
Paste entry from clipboard
Cut out entry and save it in the clipboard
Show entries in the tool database
Save the turret assignment
Close the tool list. You decide whether the changes
made remain in effect
The input window of the selected tool is opened
for editing
Load the turret list of the Machine mode of opera-
tion