smart.Turn units | Units – Special operations
2
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
199
Program section repeat unit
Use the Repeat unit to program a program section repeat. The unit
consists of two inseparable parts. Program the unit with the Start
form immediately before the repeatable part, and the unit with the
End form immediately behind the repeatable part. Be sure to use
the same variable number here.
Unit name: REPEAT / Called cycle: None
Start form:
AE: Repetition
0: Beginning
1: End
V: Variable number 1-30 – counting variable for the iteration
loop
NN: Number of repetitions
QR: Save workpiece blank
0: No
1: Yes
K: Comment
End form:
AE: Repetition
0: Beginning
1: End
V: Variable number 1-30 – counting variable for the iteration
loop
Z: Additive datum shift
C: C-axis incremental shift
Q: No. axis C
K: Comment
To Next Page
Loading...
