DIN/ISO programming | Lateral surface contours
4
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
289
Linear pattern on lateral surface G411-Geo
G411 defines a linear hole or figure pattern on the lateral surface.
G411 is effective for the hole/figure defined in the following block
(G310..G315, G317).
Parameters:
Q: Number of figures
Z: Start point
C: Start. angle
CY: Start point as linear value (reference: unrolled Reference
diameter)
ZE: Final point
ZEi: Final point – distance between two figures
W: Final angle
Wi: Final angle – Angle between two figures
A: Angle to Z axis (default: 0°)
R: Length – total length of pattern
Ri: Length – Incremental distance
If you program Q, Z and C the holes/figures will be
ordered in a regular manner along the circumference
Program the hole or figure in the following block
without a center
The milling cycle calls the hole/figure in the following
block—not the pattern definition
To Next Page
Loading...
