DIN/ISO programming | Front and rear face machining
4
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
395
Linear segment on front/rear face G101
G101 moves the tool on a linear path at the feed rate to the Final
point.
Parameters:
X: Final point (diameter value)
C: End angle
XK: Final point (Cartesian)
YK: Final point (Cartesian)
Z: Final point
Parameters for contour description (G80):
AN: Angle to positive XK axis
BR: Chamf./round. – defines the transition to the next contour
element
When entering a Chamf./round., program the theoretical end
point.
No entry: Tangential transition
BR = 0: No tangential transition
BR > 0: Rounding radius
BR < 0: Width of chamfer
Q: Intersect. pt. or Final point if the line segment intersects a
circular arc (default: 0)
0: Near point of intersection
1: Far point of intersection
Programming:
X, C, XK, YK, Z: Absolute, incremental or modal
Program either X–C or XK–YK
Using the parameters AN, BR and Q is only allowed if
the contour description is concluded by G80 and used
for a cycle.
To Next Page
Loading...
