NC programming | smart.Turn and DIN/ISO programming
1
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
43
Structured NC program
smart.Turn and DIN PLUS programs are structured in fixed
sections.
The following program sections are created automatically with a
new NC program:
PROGRAM HEAD: Contains information on the material of the
workpiece, the unit of measure as well as further organizational
data and setup information as a comment
CHUCKING EQUIPMENT: description of the workpiece clamping
situation
BLANK: The BLANK is stored. Programming a blank activates
Contour follow-up
FINISHED PART: The FINISHED PART is stored. It is advisable
to describe the complete workpiece as a FINISHED PART. The
units or fixed cycles use NS and NE to indicate the workpiece
section to be machined.
MACHINING: Use units and cycles to program the individual
machining steps. In a smart.Turn program, the START unit is
located at the beginning of the machining process, and the END
unit at the end
END: indicates the end of the NC program
If required, for example for machining with the C axis or when
programming with variables, you add further program sections.
Use the ICP editor (Interactive Contour Programming)
submode for describing the contours of workpiece
blanks and finished parts.
To Next Page
Loading...
