DIN/ISO programming | Programming variables
4
468
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Reading the current NC information
Use the following syntax to read NC information that was
programmed with G codes.
Identification codes for NC information
#n0(X)
Last programmed position X
#n0(Y)
Last programmed position Y
#n0(Z)
Last programmed position Z
#n0(A)
Last programmed position A
#n0(B)
Last programmed position B
#n0(C)
Last programmed position C
#n0(U)
Last programmed position U
#n0(V)
Last programmed position V
#n0(W)
Last programmed position W
#n0(CW)
Tool insert angle (0 or 180 degrees)
#n18(G)
Active working plane
#n40(G)
Status of TRC
#n47(P)
Current safety clearance
#n52(G) Oversize G52_Geo taken into account 0=no / 1=yes
#n57(X)
Oversize in X
#n57(Z)
Oversize in Z
#n58(P)
Equidistant oversize
#n95(G) Programmed feed type(G93/G94/G95)
#n95(Q)
Spindle number of the last programmed feed rate
#n95(F)
Last programmed feed rate
#n97(G) Programmed speed type (G96/G97)
#n97(Q)
Spindle number of the last programmed speed type
#n97(S)
Last programmed speed
#n120(X)
Reference diameter X for calculating CY
#n147(I)
Current safety clearance in working plane
#n147(K)
Current safety clearance in infeed direction
Access to current NC information
#nx(select) x = G-code number
select = designates the information to be
read
Active working plane
#n18(G)
17: XY plane (front or rear)
18: XZ plane (turning)
19: YZ plane (plan view / lateral surface)
To Next Page
Loading...
