smart.Turn units for the Y axis | Units – Milling in Y axis
3
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
227
Centric polygon milling, YZ plane unit
The unit mills the centric polygon defined with ICP in the YZ plane.
Unit name: G843_Y_MANT / cycles: G843; G844
Further information: "Centric polygon - roughing G843",
Page 595
Further information: "Centric polygon - finishing G844",
Page 596
Contour form:
FK: ICP contour number
NS: Starting block no. of contour – beginning of contour
section
Cycle form:
QK: Machining operation
Roughing
Finishing
P: Maximum infeed
I: Contour-parallel oversize
K: Infeed-direction oversize
H: Mill cutting direction
0: Up-cut
1: Climb
U: Overlap factor – defines the overlap of milling paths (default:
0.5) (range: 0 to 0.99)
Overlap = U * milling diameter
V: Overrun factor – defines the distance by which the tool
should pass the outside radius of the workpiece (default: 0.5)
FZ: Approach feed (default: active feed rate)
RB: Return plane (default: back to start position)
Further forms:
Further information: "smart.Turn unit", Page 78
Access to the technology database:
Machining operation: milling
Affected parameters: F, S, FZ, P
To Next Page
Loading...
