Overview of units | Units – "Turning" group
9
662
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
9.1 Units – "Turning" group
"Roughing" group
Unit Description Page
G810_ICP G810 Longitudinal in ICP
Roughing an ICP contour longitudinally
Page 86
G820_ICP G820 Transverse in ICP
Roughing an ICP contour transversely
Page 88
G830_ICP G830 Contr. parallel in ICP
Roughing parallel to the contour in ICP
Page 90
G835_ICP G835 Bidirectional in ICP
Roughing an ICP contour in two directions
Page 92
G810_G80 G810 Longitudinal, direct
Longitudinal roughing with direct contour input
Page 94
G820_G80 G820 Transverse, direct
Transverse roughing with direct contour input
Page 155
"Finishing" group
Unit Description Page
G890_ICP G890 Contouring in ICP
Finishing an ICP contour
Page 150
G890_G80_L G890 Contouring, direct longitdnl.
Longitudinal finishing with direct contour input
Page 153
G890_G80_P G890 Contouring, direct transverse
Transverse finishing with direct contour input
Page 155
G85x_DIN_E_F_G G890 Relief, type E,F,DIN76
Finishing the undercuts according to DIN509 type E and F and the
thread undercut DIN76
Page 157
To Next Page
Loading...
