NC programming | smart.Turn and DIN/ISO programming
1
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
45
Linear and rotary axes
Principal axes: Coordinates of the X, Y and Z axes refer to the
workpiece datum.
C axis as reference axis:
Angle data are given with respect to the datum of the C axis
C-axis contours and C-axis operations:
Positions on the front/rear face are entered in Cartesian
coordinates (XK, YK) or polar coordinates (X, C)
Positions on the lateral surface are entered in polar
coordinates (Z, C). Instead of C, the linear value CY is used
("unrolled" reference diameter)
smart.Turn mode of operation respects only address
letters of the configured axes.
Units of measure
You write NC programs in metric or inch values. The unit of
measure is defined in the Unit box.
Further information: "PROGRAM HEAD section", Page 60
Once the unit of measure has been defined, it can no
longer be edited.
To Next Page
Loading...
