HEIDENHAIN CNC PILOT 640 - Subprogram Call Unit

smart.Turn units | Units – Special operations
2
198
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Subprogram call unit
The unit calls the subprogram defined in L.
Unit name: SUBPROG / Called cycle: Any subprogram
Contour form:
L: Subprogram - Name
Q: Number of repetitions (default: 1)
LA-LF: Transmiss.value
LH: Transmiss.value
LN: Transmiss.value – reference to a block number as contour
reference
Is updated during block numbering.
Cycle form:
LI-LK: Transmiss.value
LO: Transmiss.value
LP: Transmiss.value
LR: Transmiss.value
LS: Transmiss.value
LU: Transmiss.value
LW-LZ: Transmiss.value
Cycle form:
ID1: Transmiss.value – text variable (string)
AT1: Transmiss.value – text variable (string)
BS: Transmiss.value
BE: Transmiss.value
WS: Transmiss.value
AC: Transmiss.value
WC: Transmiss.value
RC: Transmiss.value
IC: Transmiss.value
KC: Transmiss.value
JC: Transmiss.value
Accessing the technology database is not possible.
The tool call is not a mandatory parameter in this unit
Instead of the text transfer value, texts can be
displayed that were defined in the subprogram. You
can also define help graphics for each line of the
subprogram
Further information: "Subprograms", Page 484