smart.Turn units | Units – Finishing
2
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
159
Measuring cut unit
The unit performs a cylindrical measuring cut with the length
defined in the cycle, moves to the breakpoint for measuring and
stops the program. After the program was stopped, you can
manually measure the workpiece.
Unit name: MEASURE_G809 / cycle: G809
Further information: "Measuring cut G809", Page 338
Overview form:
EC: Machining location
1: Outside
-1: Inside
XA, ZA: Start point of contour
R: Length of measuring cut
P: Measuring cut oversize
Contour form:
O: Approach angle
If an approach angle is entered, the cycle positions the tool over
the starting point taking into account the safety clearance and
from there plunges at the specified angle to the diameter to be
measured.
ZR: Start point blank – collision-free approach for inside
machining
Cycle form:
QC: Machining direction
0: –Z
1: +Z
V: Measuring cut counter – number of workpieces after which
a measurement is performed
D: Additive correction (numbers: 1 to 16)
WE: Start t.
0: Simultaneously
1: First X, then Z
2: First Z, then X
I, K: Breakpoint Xi for measuring and Zi
AX: Departure position X
Further forms:
Further information: "smart.Turn unit", Page 78
To Next Page
Loading...
