TURN PLUS | Full-surface machining with TURN PLUS
7
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
651
Defining the chucking equipment for full-surface
machining
The full-surface machining sequence is defined in the chucking-
equipment dialog. You also define the datums, pick-up position and
cutting limits in this dialog.
Example of first setup for full-surface machining
Parameter:
No. of clamping H: CHUCKING EQUIPMENT 1
Spindle number AWG D:
0: Main spindle
Clamp type R:
0: J=Free length
1: J=Fixing length
Edge of chuck Z: no input (AWG uses the value from the user
parameters)
Chuck jaw reference B: no input (AWG uses the value from
the user parameters)
Clamping length or Unclamping length J: Enter the clamping
length or free length
Cutting limit, outside O: is calculated by AWG (if external
clamping is used)
Cutting limit, inside I: is calculated by AWG (if internal clamping
is used)
Overlap jaw/workpiece K: overlap of jaw/workpiece
Chuck diameter X: clamping diameter of workpiece blank
Chuck form Q:
5: Outside chucking
5: Inside chucking
Shaft machining AWG V: Select the desired AWG strategy
Example: Defining the first chucking equipment
...
CHUCKING EQUIPMENT 1
H0 D0 R0 J100 K15 X120 Q4 V0
...
To Next Page
Loading...
