HEIDENHAIN CNC PILOT 640 - Automatic Job

NC programming | Automatic job
1
74
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
1.5 Automatic job
In Program run submode, the control can execute several main
programs in succession without you needing to reselect and
start these programs. For this purpose you create a program list
(Automatic jobs) that is run in Program run submode.
Enter the quantity, i.e. the number of repetitions, for each main
program.
All program calls are saved with the complete path. In this way, you
can also start project-dependent programs.
Opening a job
In smart.Turn operating mode, you create an automatic job with
the file extension .job. Automatic jobs are project-independent
and always stored in the default directory TNC:\nc_prog_ncps.
Creating a new automatic job:
Select the Prog menu item
Select the New menu item
Select the New automatic job menu item
Enter the file name.
Press the Save soft key
Opening an existing automatic job:
Select the Prog menu item
Select the Open … menu item
Switch to the .job file type
Press the Open soft key