NC programming | Automatic job
1
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
75
Editing a job
In an automatic job, you link main programs in order to execute
them successively in the Program run submode.
Creating a new automatic job:
Select the Extras menu item
Select the Program call menu item
Select the main program.
Press the Open soft key
Enter the number of repetitions in the Q
parameter, if required
If you do not program a repetition the control runs the
program once. The program is not run if you enter a 0.
Example: Automatic job
%autorun.job "TURN_V1.0"
N1 L"TNC:\nc_prog\ncps\234.nc" Q3
N2 L"TNC:\Project\Project3\ncps\10785.nc"
N3 L"TNC:\nc_prog\ncps\Huelse.nc" Q12
. . .
To Next Page
Loading...
