DIN/ISO programming | Programming in ISO Mode
4
242
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
DIN/ISO programs of predecessor controls
The DIN/ISO program formats of the predecessor controls
MANUALplus 4110 and CNC PILOT 4290 differ from the format of
your current control. However, you can use the program converter
to adapt programs of the predecessor control to the new control.
When opening an NC program, the control recognizes the
programs of predecessor controls. The program concerned will be
converted after a confirmation prompt. CONV_... will be prefixed to
the program name.
This converter is also part of the Transfer submode.
DIN/ISO programs not only have new solutions for tool
management, technology data, etc., but also for contour
description and variable programming.
Remember the following when converting DIN/ISO programs of
the MANUALplus 4110:
Tool call: The loading of the tool number depends on whether
the program is a multifix program (2-digit tool number) or turret
program (4-digit tool number):
2-digit tool number: The tool number is loaded as ID and
entered as the tool number T1
4-digit tool number (Tddpp): The first two digits of the tool
number (dd) are loaded as ID and the last two (PP) as T
Workpiece-blank definition: A G20/G21 workpiece-blank
definition of the 4110 becomes an AUX. BLANK
Contour descriptions: In 4110 programs, the fixed cycles
are followed by the contour description. During conversion
the contour description is converted to an AUX. BLANK. The
associated cycle in the MACHINING section then refers to this
auxiliary contour
Variable programming: Variable accesses to tool data, machine
dimensions, D compensation values, parameter data and events
cannot be converted. These program sequences have to be
adapted
M functions are left unchanged
Inches or metric: The converter cannot detect the unit of
measure of the 4110 program Consequently, no unit of measure
is entered in the target program. This has to be completed by
the user
To Next Page
Loading...
