smart.Turn units | Units – Special operations
2
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
201
Tilt plane unit
The unit executes the following transformations and rotations:
Shifts the coordinate system to the position I, K
Rotates the coordinate system by the Angle B; reference: I, K
Shifts, if programmed, the coordinate system by U and W in the
rotated coordinate system
Unit name: G16_ROTWORKPLAN / Called cycle: G16
Further information: "Tilting the working plane G16", Page 587
Tilt plane form:
Q: Tilt plane
0: OFF (deactivate tilting)
1: ON (tilt working plane)
B: Angle – plane angle (reference: positive Z axis)
I: Reference pt. – plane reference in X direction (radius value)
K: Reference pt. – plane reference (in Z)
U: Shift in X
W: Shift in Z
Please note:
Q0 resets the working plane. The datum and
coordinate system defined before the unit are then in
effect again
The positive Z axis is the reference axis for the Angle
B. This also applies to a mirrored coordinate system
X is the infeed axis in a tilted coordinate system. X
coordinates are entered as diameter coordinates.
Other datum shifts are not permitted as long as tilting
is active
To Next Page
Loading...
