TURN PLUS | Example
7
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
643
7.5 Example
On the basis of the production drawing, the working steps for
defining the contour of the blank and finished part, the setup
procedures and automatic working plan generation are explained.
Workpiece blank: Ø60 x 80
Material: Ck 45
Creating a program
Creating a program:
Select the Prog menu item
Select the New menu item
Select the New DINplus program Ctrl+N menu
item
The control opens the Save as dialog box
Enter a program name
Press the Save soft key
The control opens the Program head (short)
dialog box
Select a material from the fixed-word list
Press the OK soft key
Workpiece blank definition
Defining the blank:
Select the ICP menu item
Select the Workpiece blank menu item
Select the Bar menu item
TURN PLUS opens the Bar dialog box
Enter the workpiece blank dimensions:
Diameter X = 60 mm
Length Z = 80 mm
Allowance K = 2 mm
Press the Save soft key
TURN PLUS displays the workpiece blank
Press the Back soft key
To Next Page
Loading...
